Author Archives: Joe Galliera
SOLIDWORKS Tech Tip – Display Fan Operating Point in SOLIDWORKS Flow Simulation
Since the Flow Simulation 2019 release, there is a new type of plot that you can show to see the operating point for any of the defined fans in a project. You can easily access this through a right-click on
... ContinuedHow Many Different Ways to Solve a Simulation Problem
How many different ways are there to solve a Simulation problem? There are probably many more ways than you think, so you may be asking yourself: “How can I be sure that I have the ‘right’ answer?” First off, while
... ContinuedHandling Interferences for Meshing in SOLIDWORKS Simulation
If you’ve ever run into the case where you get the following message, seen below in Image 1: “At least two bodies are interfering. Do you want to check interference?” Image 1: Detected bodies that are interfering. Agghhh! And I’m
... ContinuedFlow Simulation’s Thermal Analysis Capabilities – Part 3
For thermal heat transfer analysis, choose SOLIDWORKS Flow Simulation over the Thermal solver in Simulation Professional, Part 3 of 3 Meshing With the exception of very few scenarios, when considering a thermal analysis solver for SOLIDWORKS, you should choose to
... ContinuedFlow Simulation’s Thermal Analysis Capabilities – Part 2
With the exception of very few scenarios, when considering a thermal analysis solver for SOLIDWORKS, you should choose to use Flow Simulation, which is a computational fluid dynamics (CFD) code.
... ContinuedFlow Simulation’s Thermal Analysis Capabilities – Part 1
With the exception of very few scenarios, when considering a thermal analysis solver for SOLIDWORKS, you should choose to use Flow Simulation, which is a computational fluid dynamics (CFD) code.
... Continued