Author Archives: Jordan Tadic
Modeling Challenge – Sketching an Approximate Sine Wave
* This is one of a series of modeling challenges you can use to test your SOLIDWORKS skills. First, read the challenge and try to figure out a solution on your own. Then, compare your solution with my good, better,
... ContinuedSOLIDWORKS Modeling Challenge – Measuring Imported Fillets
* This is one of a series of modeling challenges you can use to test your SOLIDWORKS skills. First, read the challenge and try to figure out a solution on your own. Then, compare your solution with my good, better,
... ContinuedModeling Challenge – Feature Tree Needles
* This is one of a series of modeling challenges you can use to test your SOLIDWORKS skills. First, read the challenge and try to figure out a solution on your own. Then, compare your solution with my good, better,
... ContinuedModeling Challenge – 3D Wireframe Sketch
*This is one part of a series of modeling challenges you can use to test your SOLIDWORKS skills. First, read the challenge and try to figure out a solution on your own. Then, compare your solution with my good, better,
... ContinuedModeling Challenge – Drafting Curved Surfaces
Just like my previous modeling challenges, give this one a shot on your own before scrolling down and reading some of the possible solutions. As always, feel free to share even more tips and tricks in the comments below. Today’s
... ContinuedModeling Challenge – Calculate Internal Volume
Continuing the modeling challenge theme I started with my last post, I’d like to review a few different ways to calculate the internal volume of an open container. There’s something to be learned from each method, but thanks to recent
... ContinuedModeling Challenge – Remove All Holes
The best way to learn a software is to continually challenge yourself in new ways. To help aid that process, I’m going to begin posting some SOLIDWORKS obstacle courses for you to test your modeling skills on. The first challenge
... Continued